Driving can become uncomfortable during hot weather. By placing a tint on your car’s window, you can shield it from harmful UV rays. You can also reduce heat damage by using car window tint film.
Auto window tinting Camarillo can improve the look and performance of your vehicle. Many people are not aware of how to apply the window tint in Norwalk. This task requires patience and an extra set.
This article will provide you with a great guide on tinting your car windows. However, you should need first to do some research regarding the tinting laws of your state.
- Get ready for tinting.
Clear away any residue from the glass. You can do this by clearing the felt from the glass. You can remove the brake lamp, side panel, or rear deck if you have a different vehicle. This will enable you to access all the parts of the window quickly and easily.
Now, wash the window with fresh soapy. Use the blade to remove any mess. You must dry the glasses with the microfiber cloth and then use the squeegee or a rake to inspect for any water spots.
This will allow you to get into every corner of the window and roll them down. Move it upwards once you’ve cleaned this area. The soap water solution should now be added to the spray bottle.
- Cut Out the Window Tint Film
If you are a first-timer, don’t use your vehicle’s window to guide you. Instead, take some cardboard and create a template to fit your car window. This will ensure that you get a perfectly shaped window without wasting film.
Make another template if you make an error. Then, add three-quarters of an inch to your seal. Now, let the quarter of an inch go to both the top and sides.
Place the template with the film on a firm surface once you have finished the template. You can then use a knife and cut the edges to give the material the same shape as your template.
Now you need to have an outline of your vehicle that matches its window. Place it on the window to confirm that the size is correct.
Ask someone to hold the film before you cut it. You must also trim around the edges to prevent gaps between your rubber seal and the edges.
- Fix The Film on The Glass
Apply the application fluid with a squeegee after determining the size of the film that will fit the window. After removing the outer layer, apply the liquid to the sticky side.
You should use less pressure and avoid creating creases and bubbles as the adhesive part of the film reacts with pressure. The film tends to stick to the glass when subjected to too much pressure. If this is the case, you need to start from the beginning.
Place the film on the glass. Use the squeegee with the tint applied. You can use even strokes to accomplish this task. You may begin from the center and move towards the edges. Make sure you lubricate the tool with soap solution before you use it.
Continue to apply the soapy liquid while you rub the film. The squeegee should be used with minimal pressure. The tint will bond to your window once you have removed the solution.
Remember to keep the edges and corners in mind. For these narrow spots, use a piece of another sponge to shape the film, so it fits in the corners.
Continue pushing the bubbles apart, increasing the pressure slowly. The tint will stick entirely to the glass once the liquid and bubbles have been removed. You won’t see any creases in the corners, bubbles or gaps.
Continue to follow the above steps for the remaining windows. You should allow the film to bond fully with the glass after you have completed the process. After 48 hours, you can clean or wind it down.
It will save you money to do the process your own way because you don’t have to hire an expert to install your window tint. You can also change the look of your car by installing a window tint. It will protect you from the sun.
However, if you are not confident enough in applying the film on your own, KEPLER provides the best auto window tinting services. Our team will do a great job of tinting and guaranteeing your satisfaction. Visit us at www.kepler-dealer.com for more information.